Expert Answers about Living Room Accessories

• How Many Slide-Out Supports Do I Need for 2 Slide-outs
• The Ultra-Fab Slide-Out Supports # UF19-960003 come in pairs and are designed to be used with one pair on each slide-out. Since you've got 2 slide-outs, you would need 2 pairs of the Ultra-Fab Slide-Out Supports. These supports are designed to support up to 1400-lbs per set and can be used on slides that have a height from the ground between 26" and 47" tall.
  view full answer...


• Recommended Slide-Out Toppers for 2009 Crossroads Cruiser Patriot Trailer
• All of our white slide-out toppers are shown on the linked page and all are 50-inches wide. Their lengths range from 5-1/2-feet up to 16-feet. You are correct that you want the topper to extend beyond the slide-out by a few inches on each side, for maximum protection from the sun's heat. For 140-1/2-inch slide-out I suggest the 12-foot model # LCV000139496. For the 42-inch the nearest size we have is the 5-1/2-foot # LCV000163273 and for the 73-inch slide-out the 6-1/2-foot Solera # LCV000163279. Solera...
  view full answer...


• Which Slide Out Toppers Are Needed for 56" Wide and 111" Wide Slide Outs
• When measuring to find the correct slide out topper, you'll want to measure from flange to flange on the outside of the slide to determine the correct fit, and you want the slide to hang over the slides about 3 inches on each side to provide adequate protection. It looks like you've measured 56" and 111" (rounded up), so you'll want to use the Solera RV Slide-Out Awning - 5'1" Wide - 48" Projection - White # LCV000163273 for the smaller slide out and the Solera RV Slide-Out Awning - 9'7"...
  view full answer...


• Recommended 5th Wheel Trailer Cover to Protect Against Wind and Rain During Winter
• For a 41 foot long trailer I recommend the Adco Olefin # AD89ZR which offers the strongest construction and best protection from the weather in all climates This cover is for trailers which are 11 foot tall measured from the roof top to the floor. You do NOT measure to the top of A/C's or vents, and you do NOT measusre to the ground. This should fit all but the tallest fifth wheel trailers. If you need a taller cover I recommend the Classic Accessories Polypro III Deluxe # 052963750638....
  view full answer...


• What Adaptor and Power Cord do I Need for My 4-Prong Female Electrical Setup on My RV?
• Thanks so much for sending me a photo. Unfortunately, the best route forward is to uninstall the female outlet installed on your trailer and install it with a male outlet like the Mighty Cord Replacement RV Power Inlet - Twist Lock - 30 Amp # A10-30INVP. After the male outlet is installed, you can now use a power cord like the Mighty Cord RV Power Cord - 30 Amps - 25' Long # A10-3025EDBK. It is important to note that this power cord will only work with a 30-amp shore power connection....
  view full answer...


• Auxiliary Transmission Cooler for 2019 Ford Expedition with 3.5L EcoBoost Engine
• A transmission cooler isn't a vehicle-specific item. As long as your transmission has two lines running from the transmission to the radiator, and you have the available space on the front of the radiator directly behind the grille, you can install a cooler. Unless you live in a climate that's freezing most of the year, it's recommended to get the largest transmission cooler that will fit in the available space. If you have 11 x 8-3/4 inches of available space, the Derale # D13503 transmission...
  view full answer...


• Adding 7-Way Connector and Brake Controller to 2013 Ford Explorer w/Factory 4-Way Trailer Connector
• To tow the trailer with the 7-Way round connector with your 2013 Ford Explorer that has a 4-Way flat connector you will need an adapter, # 37185. On this adapter, the white wire must be grounded to the vehicle frame in order for the connector to function. The other 3 wires can be tied up if they are not going to be used. The blue wire is used for electric brakes. The black wire is for 12 volt power. And the purple wire is for reverse lights If the trailer does not have electric brakes,...
  view full answer...


• Parts Needed to Add a 7-Way Trailer Connector to a 2011 Honda CR-V
• In order to install a 7-Way trailer connector on your 2011 Honda CR-V you will first need to either have a 4-Way flat or add one using # 118427. Then you would need to use # ETBC7 which will provide the 7-Way and accessories you will need to make the 12 volt circuit live. I have included some links to help with the ETBC7 installation. The ETBC7 installation links mention the brake and brake controller installation but if you do not want to add a brake controller then you can skip that...
  view full answer...


• Recommended Cover for 2022 Grand Design Solitude 380FL
• The Adco Olefin HD All-Climate + Wind RV Cover for 5th Wheel Toy Hauler # AD89ZR will be a better choice then The Classic Accessories PermaPRO Deluxe Extra Tall 5th Wheel Cover or Toy Hauler Cover # CA80-299-203101-RT. The Adco cover works best for long-term storage in all climates and high winds. The top panel of the cover is constructed of a Olefin HD fabric which blocks harmful UV rays that can cause cracking and fading. The side panels are constructed of a non-abrasive, triple-layer...
  view full answer...


• Parts Needed to Install Derale 15301 Cooler in 2009 Nissan Frontier 4.0
• I spoke with my contact at Deraile and he said to install the Derale Combination Transmission/Engine Oil Cooler # D15301 on your 2009 Nissan Frontier you will need installation kit # D15751 and Derale -8 AN Female Swivel x 1/2" Barb Hose Fitting # D98202. It comes with a thermostatic controlled sandwich adapter so that it will allow your vehicle to reach operating temperature. The Derale Remote Transmission Filter Kit w/ Temperature Gauge # D13091, that you referenced would be a good...
  view full answer...


• What Camper Cover do You Recommend for My 2020 NuCamp TAG Boondock XL?
• For your NuCamp Boondock XL, the best option available is the Classic Accessories Deluxe PolyPro III Heavy-Duty Cover for R Pod Trailer Up to 16-1/2' Long # CA80198. With the Deluxe PolyPro III, you will have some extra room in the cover to accommodate your Yakima setup with the Slim Shady awning like the # Y56VR. However, with the Yakima Rack and Slim Shady Awning, there is the potential for these accessories will stretch and damage the cover. The absolute safest option is to remove...
  view full answer...


• What Hitch Reducer and Locking Hitch Pin Do You Recommend for a Curt 5 Bike Rack on a 3-Inch Hitch?
• In order to use the Curt 5 Bike Rack - 2" # C18065 on your 3-inch hitch on your RV, I recommend the Curt Hitch Receiver Reducer Sleeves - 3" to 2-1/2" or 2" # C45408. The reducer will allow you to use the Curt 5 Bike Rack with your 3-inch hitch receiver. As for as a compatible pin and lock that will work for both the hitch, the reducer, and the rack, I confirmed with my contact at Curt that the pinhole diameter of these accessories is 5/8". With that being said, I recommend the Fastway...
  view full answer...


• Recommended Adjustable Cushioned Ball Mount for 2" Hitch on 2020 Chevy 2500HD
• I have a solution for you, but the Curt Rebellion XD # C45949 is not compatible with weight distribution hitches. Instead, I recommend using the Gen-Y Ball Mount # 325-GH-1224, which has a 16000-lbs capacity and can give you up to 5" of drop to help ensure that your trailer is towed level. This ball mount also has a dual hitch ball (2" and 2-5/16") to allow you to tow both of your trailers, so it's a flexible option that will allow you to cover a lot of different setups. I've linked a...
  view full answer...


• Carrying 4 Bikes and a Hitch Mounted Cargo Carrier on an RV Trailer Hitch Receiver
• Using the Malone Dual Hitch Receiver # MPG544 will be difficult with a bike rack and cargo carrier. The bike rack will not give you much room for cargo on the carrier. Even if the bike rack's shank has a rise it'll only be 3 or 4 inches. You may be able to add a front mount hitch on your RV and then carry either the cargo carrier or bike rack on the front. Since an RV has a longer wheelbase than a typical vehicle not all accessories are designed to withstand the additional bouncing around...
  view full answer...


• Best Transmission Cooler, Cold Air Intake, and Tuner for 2015 GMC Yukon XL 5.3L Towing in Mountains
• All of our transmission coolers are actually designed to be used in addition to your OEM cooler. For the 5.3L V8 on your 2015 GMC Yukon XL (excluding 323 c.i.) the best option we have is the Derale # D13503. These coolers aren't necessarily vehicle specific. You just need to make sure that you have enough room under your hood for it. This cooler measures # 11" wide x 8-3/4" tall x 7/8" deep. I have linked a helpful article on transmission coolers that you can reference for the best place...
  view full answer...


• What Parts Are Needed or Recommended for Putting a Fifth Wheel Hitch on a 2008 Nissan Titan 8FT Bed
• For your 2008 Nissan Titan, I would suggest the Reese Semi-Custom Install kit, part # RP30035-405. This kit has all the hardware you will need to get the truck set up for a traditional bed rail fifth wheel hitch. I have added links to the instructions as well. Reese 16K Fifth Wheel, part # RP30051 is a fifth wheel equipped with a slider, which you will not need since you have a full 8 foot bed. Instead I would recommend Reese part # RP30047. It is the same as 30051 but without the sliders....
  view full answer...


• How to Carry a Tandem Kayak with a 2017 Ford Edge Titanium with a Panoramic Roof
• For your 2017 Ford Edge with the glass roof I recommend going with the Yakima JetStream roof rack. This includes the 50" JetStream Crossbars # Y00425 along with the BaseLine Towers # Y28TR, and Fit Kit # Y06102. To lock this roof rack you will also need the SKS Lock Cores # Y07204. This system has a weight capacity of 165 lbs. The Yakima JayLow Kayak Carrier # Y04073 is one of our most popular carriers that will leave enough room on your roof for you to add another accessory if necessary....
  view full answer...


• What Hitch Extender do I need for a Thule Rack on a 2010 Jeep Wrangler Unlimited with Mud Spare Tire
• To determine the extension length you need to take a measurement on the back of your wrangler. Take a yard stick or a dowel rod and stand it straight up and down on the ground and have it touch the outer most spot on the tire. Measure from the center of your hitch pin hole to the yard stick. This measurement is the minimum clearance you will need. Next, measure from the upright on the bike rack straight back to the hitch pin hole on the bike rack. This is the clearance the bike rack provides....
  view full answer...


• Recommended Roof Rack and Kayak Carrier for Flush Mounted Rails on 2014 Lexus GX 460
• We can help you find the parts you're looking for, and really, if you're using a set of crossbars with T-slot mounting paired with accessories that mount in those channels the clearance from the roof won't be a factor. With that said, the Inno kit you mentioned would potentially work, but I do have something that has a bit taller towers to give you some extra clearance from the roof. I recommend using the Yakima Roof Rack for 2014 Lexus GX460 using parts # Y00425, # Y00145 and # Y28FR....
  view full answer...